Filtering Reports

Synergy report tables are designed so that you can filter data displayed by specific values for any of the columns, allowing your reports to be narrowed down to very specific categories.

The number of rows displayed is shown in the bottom right hand corner of the report.

This number is updated if any filters are applied.

To filter data displayed in a column, right-click on the column heading. A checkbox list appears with values for the column. The following screenshot shows the Command Report on the Users tab with the checkbox list for the Activity column.

Select the checkboxes for the values you want included in your report. If you want all values in the list to be included, select All Values.

When you have made your filter selections, click Finished Selection. You can filter any column on the report table in the same manner. The resulting report will display only the column values that you specified.

Setup: Column values are determined during system setup.

Visit us online at www.synecticsglobal.com